top of page
  • Writer's pictureMichael Kent

How to repair a Smashed Car Window

Nobody likes to deal with smashed window Leeds. However, securing the window until repairs can be made is essential. Every car owner should know how to fix a window that has been smashed by any type of mishap. Although driving with shattered car glass is generally not a safety concern, it should be fixed or replaced as soon as feasible. Clear away the shattered glass and cover the window while you wait. Not only will this help keep out severe weather and wind, but it can also help keep the vehicle safe in the event of theft.

Steps to repair a broken window

1. Planning

Put on a pair of gloves to protect your hands before handling glass fragments. Make things simpler for yourself when doing smashed window Leeds by purchasing a bag or container that will allow you to easily dispose of or recycle the waste.

2. Remove any broken glass from the area

Remove the largest shards of glass first. The shattered bits can be collected and thrown into a bag or container using your hands. Remove any remaining pieces of glass that are still stuck to the vehicle with care. Afterwards, use a shop vac to remove the smaller pieces of broken glass from the automobile, around the window frame, and down into the seal. The long vacuum attachment makes it easier to clean small shards from the carpet, seat, and even the car door.

3. Window trim needs to be cleaned

Preparing the surfaces around the window for optimal adherence is the next step. To ensure a good bond between the tape and the surface it's covering, make sure all debris, dust, and accumulation is removed. Window seals and car frames should be cleaned with a moist cloth on both sides. It's time for this area to dry out for a little while longer.

4. The plastic covering is now in place

From inside the vehicle, place the plastic over its frame. Temporarily secure the bag in place with pieces of masking tape by holding it against the top edge of the frame. Other forms of tape can damage the paint of the automobile or become difficult to remove from the glass of the car afterwards.

5. The plastic cover must be tightly fastened

Tape six to ten long strips of masking tape together. Pull the plastic toward one side of the car's frame as you smooth it out. Use one piece of tape at a time to secure the plastic to the window frame. If the plastic isn't stretched tightly enough, it will flap in the wind and make a lot of noise when you're driving.

6. Sealing the window coverings is the final step

Next, apply more pieces of tape to the seal surrounding the window to ensure a tight seal. Additional tape will help hold the plastic covering in place even if there is wetness or high air pressure as you drive. There should be no gaps between the plastic and the window frame that could allow moisture or air to enter. There are more chances that the plastic will tear before the window lock repair Leeds can be done if there are gaps.

7. Apply a second coat to the outside

Extra plastic should be used if the temporary covering will be in place for several days, such as over the weekend or during inclement weather. Apply another layer of plastic from the exterior to replicate steps four to six. That should finish the job of covering a car window that has been smashed.

Keep in mind that this is simply a short-term fix! Window replacement should be done as soon as possible by contacting a locksmith for window and door lock repair Leeds to make sure both the people inside the car and the people on the road are safe. You can contact the Leeds locksmith for all such issues.

10 views0 comments


bottom of page